Bc-technologies M720 Dryer Control (DE, DP, DI Series) Manuel d'utilisateur télécharger pdf (Page 13)

Chapter 3

Operation

The basic operation of the machine consists of the following steps:

1. Select a drying program

2. Starting the program

3. Program running

4. Program completed

3.1 Selecting a Drying Program

Before a drying program is started, the user must make sure that the correct drying program is

selected. The drying program is displayed in the upper line of the overview screen (see Chapter 4

on page 16).

If the correct program is not selected (for example, a drying program for towels is selected, but

the current machine load is a batch of sheets), the user must select another program. If the correct

program has been selected, step 2 can be done (see Section 3.1.3 on page 11).

For choosing a program, there are 2 possibilities. If a predeﬁned program can be used, Section

3.1.1 on page 10 is applicable. It is also possible to manually conﬁgure a single cycle program.

This can be used in cases where there is no suitable predeﬁned program, for example if a batch is

already partially dry, or in case of special material which is not normally done with this machine.

In case a single cycle program is necessary see Section 3.1.2 on page 11.

3.1.1 Selecting an adjusted program

From the overview screen, the user can go to the program selection screen by pushing the SELECT

PROGRAM key, or by directly entering the program number via the numeric keypad.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Pas de commentaire

Bc-technologies M720 Dryer Control (DE, DP, DI Series) Manuel d'utilisateur Page 13